topic Re: Hi Automation Pros, My Condition result is false still its executing the next steps, any suggestions on how to fix it? in Workato Pros Discussion Board

Hi Automation Pros, My Condition result is false still its executing the next steps, any suggestions on how to fix it?

harendra — Tue, 09 Aug 2022 18:12:47 GMT

Re: Hi Automation Pros, My Condition result is false still its executing the next steps, any suggestions on how to fix it?

vishwanathgouri — Tue, 09 Aug 2022 18:17:35 GMT

Can you share step10 setup.

Re: Hi Automation Pros, My Condition result is false still its executing the next steps, any suggestions on how to fix it?

ngeorgakopoulos — Tue, 09 Aug 2022 18:21:33 GMT

Have you configured an IF or IF-ELSE statement ?

Re: Hi Automation Pros, My Condition result is false still its executing the next steps, any suggestions on how to fix it?

veeravenkatasat — Tue, 09 Aug 2022 18:28:41 GMT

can you please check if the Matched returning True /Flase if yes then write a condition if Matched equals to True set this and check once.

Re: Hi Automation Pros, My Condition result is false still its executing the next steps, any suggestions on how to fix it?

ab — Tue, 09 Aug 2022 18:55:36 GMT

Could you share first 10 steps? Is there any Repeat action there?

Re: Hi Automation Pros, My Condition result is false still its executing the next steps, any suggestions on how to fix it?

harendra — Tue, 09 Aug 2022 18:58:10 GMT

Yes there is repeat action there

Re: Hi Automation Pros, My Condition result is false still its executing the next steps, any suggestions on how to fix it?

ab — Tue, 09 Aug 2022 20:07:52 GMT

It's a bit misleading with repeated actions as it shows all the steps processed during all loop passes. You can use some variable to track if this condition worked and then output it using Logger. But I'm 99% sure all works correctly 🙂

Re: Hi Automation Pros, My Condition result is false still its executing the next steps, any suggestions on how to fix it?

phil-mau — Tue, 09 Aug 2022 23:00:19 GMT

You are correct that it is misleading when there is a repeat loop. Today, the job history will show the last successful run of the actions within a loop.

As Alexey suggested, you can put an if statement within block 10 that catches the condition you're looking for and output whatever you desire in a logger action.